AXIAL SCX10 III Jeep Wrangler +3mm Aluminum Wheel Hex Adapters by GPM SCX3010/+3M  [SCX3010/+3M]

Wheel hex adapters for SCX10 III

This GPM aftermarket kit provides aluminum wheel hex adapters designed for Axial platforms, intended to connect the front CVD and rear drive shafts to the wheels on scale RC rigs. The adapters extend the wheel hub by +3mm to widen track width, helping reduce excess gap between wheel and hub and improving lateral stability during trail and scale driving.

The set contains 4pcs aluminum hex adapters and 4pcs stainless steel screw shafts M3.5x2x11.8, original part number AXI232018. The adapters are produced from 6061 T6 aluminum for a balance of light weight and tensile strength; they are intended for RC-scale use only.

Installation notes: these adapters replace the stock hexes at the wheel interface, using the supplied stainless shafts for retention. Fitment requires checking spline alignment with the wheel and CVD, torquing hardware to appropriate thread engagement, and verifying wheel runout after installation. Use accompanying hex driver sizes for correct screw torque and recheck after initial runs.