AXIAL SCX10 III JEEP WRANGLER Aluminium Rear Bumper Mount 5pc set by GPM SCX3331R  [SCX3331R]

Aluminium rear bumper mount for SCX10 III

This is an RC-scale aluminium rear bumper mount designed for the AXIAL SCX10 III JEEP WRANGLER platform, produced by GPM as part number SCX3331R. The part pairs a machined 6061 T6 aluminium body with the mounting hardware needed to secure the rear bumper and contribute to chassis stability on scale-scale RC models.

The component uses a 3D cut, hollowed profile intended to reduce weight while keeping stiffness in mounting points. The design purpose is to stabilise the chassis-to-bumper interface during trail driving and scale collisions, not for full-size vehicle use. Hardware included provides the fasteners for direct replacement or upgrade of the stock plastic mount.

When planning an installation, check clearance around the rear body mounts and existing bumper supports on your SCX10 III Wrangler replica. The aluminium mount changes how loads transfer to the rear section, so re-torque fasteners after a few runs and verify alignment with the bumper and chassis rails.

Use this aluminium rear bumper mount to replace or upgrade the stock rear mount on an AXIAL SCX10 III Wrangler scale chassis, improving mounting rigidity and hardware durability for trail and scale use.