AXIAL SCX24 Hex Adapters 3.5mm Thick by GPM SCX2410X/3.5  [SCX2410X/3.5]

Brass hex adapters for wheel hubs

This 8pcs set fits small-scale AXIAL 1/24 models and supplies brass hex adapters intended for wheel mounting and hub connection. The metal hexs are made in brass with a 3.5mm thickness as stated, and the kit includes steel pins for securing the adapter to the hub. Each brass adapter adds a small measured weight effect of about 1g, useful for balance and steering feel at model scale.

The adapters locate at the wheel hex position to link the wheel to the front CVD or the rear drive shaft, replacing the standard plastic hex in cases where a metal interface is preferred for durability and repeatable fit. Installation uses the supplied 1.5x5 steel pins to retain the adapter in the hub; inspect pin alignment and hub fit during assembly to avoid binding.

Use this set when you need a compact brass replacement hex for SCX24 DEADBOLT or compatible 1/24 Jeep Wrangler JLU CRC platforms, particularly for tighter hub clearance or when adjusting unsprung weight and wheel retention characteristics.