Axial SCX6 Jeep 1/6 7075 Aluminum Steering Servo Arm by JAZRIDER JR-SCX607-TI  [JR-SCX607-TI]

Steering servo arm for Axial SCX6

This is an RC-scale steering servo arm intended for Axial SCX6 1/6 Jeep models, supplied under the JAZRIDER JR-SCX607-TI part number. The alloy arm replaces common plastic steering arms to provide a firmer mechanical link between the servo output and tie-rods on scale trail rigs.

Compatibility is focused on Axial SCX6 Jeep JLU Wrangler 1/6 scale setups; verify spline pattern and mounting hole alignment on your stock servo before fitting. The part is machined from 7075 aluminum, chosen for its strength-to-weight balance in RC applications.

Installation notes: remove the original servo arm, check spline engagement, position the new arm on the servo spline, and secure with the original retaining screw or compatible fastener. After installation, confirm full range of motion and that steering geometry (toe and tie-rod clearances) remain within your setup targets. This component is intended as a replacement/tuning part for RC steering linkages and not for full-scale vehicles.