Axial SCX6 Jeep 1/6 Aluminum Front Steering Knuckle Set by JAZRIDER JR-SCX601-TI  [JR-SCX601-TI]

Front steering knuckles for SCX6 Jeep

This JAZRIDER replacement is an RC-scale front steering knuckle set intended for Axial 1/6 SCX6 Jeep models. The kit uses aluminum with a titanium-style finish to replace stock plastic parts where increased rigidity and predictable wear are desired. The components serve a clear tuning role: increase steering response consistency and reduce flex at high steering loads.

Fit and purpose: the pieces are designed for the Axial SCX6 platform and are presented as direct swap components for the front axle assemblies. When installed they change the steering geometry characteristics in ways typical for metal knuckles — stiffer steering linkages and reduced deformation under load — which is useful when adjusting servo centering, steering throw limits, or suspension damping to match handling goals.

Installation notes: remove the stock knuckles and compare pivot points, bearing bores, and link mounting locations before final assembly. Verify smooth rotation on existing wheel hubs and confirm there is no binding across the full suspension travel. After fitting, re-check steering trim and tracking to account for any geometry shift introduced by the metal parts.

Use these knuckles when you need a metal replacement to stabilise steering inputs and support progressive tuning of steering and suspension on Axial SCX6 1/6 scale Jeeps.