AXIAL SCX6 JEEP JLU WRANGLER 20Cr Steel Spiral-cut Ring & Pinion Gear set 32T/9T/1.35 Mod by GPM SCX60932TS  [SCX60932TS]

Ring & Pinion upgrade for SCX6

This GPM aftermarket ring and pinion pair is an RC-scale drivetrain replacement designed for the AXIAL SCX6 platform. The set uses hardened 20Cr carbon steel with a black treatment and helical spiral-cut geometry intended to improve load distribution and running smoothness compared with standard straight-cut parts. The module is listed as 1.35 and the gear sizes are 32T ring and 9T pinion, intended for installation inside the front or rear axle diff housing where the factory ring and pinion live.

Functionally this pair transfers motor torque through the differential to the axle shafts, and because the gears are spiral-cut their meshing tends to run quieter and with reduced localised stress when properly set up. The part is presented as a high-speed ratio replacement for the factory 12/43T 1.0 mod gear set referenced by AXI252007; verify fit and gear mesh before committing to final assembly.

Installation notes: confirm the 1.35 module pinion seats correctly on the motor output or differential pinion journal, set backlash to a controlled mesh to avoid premature wear, and inspect bearings and diff housing for play before tightening. Use appropriate lubricant on gear teeth and re-check mesh after a short run-in session at low speed. This component is strictly for RC model use.

For scale crawlers on the SCX6 chassis this ring and pinion set offers a hardened steel option and spiral-cut toothform to refine drivetrain feel and durability when installed and meshed correctly.