AXIAL SCX6 JEEP JLU WRANGLER 4WD Carbon Steel CVD Drive Shaft by GPM SCX6037S  [SCX6037S]

CVD drive shafts for SCX6 platforms

This is a scale RC front and rear CVD drive shaft set designed for AXIAL SCX6 JEEP JLU WRANGLER 4WD applications. The assembly is a 6pc set intended for the drive shaft area on both front and rear axles, supplied with screw pins for mounting. It is an aftermarket replacement part produced by GPM, model SCX6037S, matching common SCX6 driveline layouts.

The parts are carbon steel CVD (constant velocity drive) components that transfer motor output into the axle assemblies. CVD configuration increases load capacity and allows larger transmission angles compared with simple dogbone shafts, which helps when running higher articulation or steeper axle angles during crawling and trail use.

Installation requires basic axle disassembly to remove the original shafts and secure the new CVD units in the front and rear drive areas using the provided screw pins. Check fitment at the axle cups and ensure pins are seated; avoid over-tightening fasteners and verify free rotation through the suspension travel before finalizing.

Use these carbon steel CVD shafts to replace worn drive components or to increase driveline robustness for articulated crawling and trail setups on SCX6-based scale rigs.