AXIAL SMT10 Aluminium Wheel Hex (+2mm) by GPM MJ0104/+2MM  [MJ0104/+2MM]

Aluminium wheel hex for SMT10

This aluminium wheel hex is a direct aftermarket accessory produced by GPM for AXIAL Racing SMT10, supplied as a 4pcs set to alter wheel offset by +2mm where chassis wheel clearance or stance tuning is required. The part is intended for RC-scale use on AXIAL SMT10 wheel assemblies and helps adjust wheel position without changing wheels or hubs.

Installation is typical for wheel hex upgrades on SMT10 platforms: remove wheel and existing hex, fit the aluminium hex onto the axle or hub following the chassis layout, then resecure wheel hardware. Check wheel clearance after installation and verify that drive pins and screws are tightened to prevent loosening under use. This part is offered as a machining-grade aluminium component to serve as a durable mounting element in the wheel assembly.

The package also contains common hardware to complete installation, included exactly as supplied:

• 2x10.9 Steel Pin - 4pcs
• 2x7 Steel Pin - 4pcs
• 2.5x2.5 Screw Shaft - 8pcs
• 1.2 Hex Socket Key - 1pc