This aluminium upper chassis link is an RC-scale replacement designed for AXIAL SMT10 platforms, supplied as a matched front/rear pair for chassis tuning and repair. The parts are intended to replace standard plastic links to provide a firmer mounting point for suspension geometry adjustments without implying any real vehicle use.
Functionally, the aluminium links help maintain more consistent camber and roll centre under load, making them useful for fine-tuning handling balance on Yeti and SMT10 Monster Jam models listed below. The design focuses on repeatable alignment and reduced flex compared with stock non-metal links.
Installation is straightforward for hobby workshops familiar with basic chassis work, the parts use common fasteners and a 3mm lock nut where required. Take care not to over-torque into composite or alloy mating points and apply a suitable thread locker on steel-to-aluminium joints when finalising setup.
Included small hardware from the original packing is provided to fit the links, verify quantities before installation and reuse any existing washers or spacers from your chassis as needed.
Copyright © 2008-2026 rcjaz.com All rights reserved
