Axial Yeti 1/10 Aluminium Rally Front and Rear Dampers (F:86mm R:110mm) by GPM YT086110FR  [YT086110FR]

Front and rear rally dampers for Axial Yeti

These dampers are a 18 pcs aftermarket set produced by GPM for Axial Yeti 1/10 scale RC cars, designed specifically for rally-style onroad tuning. The units are hand-assembled and intended as direct-fit suspension upgrades to alter ride height and damping behaviour for faster, flatter onroad rally runs.

Key mechanical details provided by the source include front length 86mm and rear length 110mm measured center-to-center at the ball ends, a damper cylinder diameter of 12.8mm, a 4mm shock shaft, and a spring coil length of 2mm. The dampers are oil-filled and feature adjustable settings for compression and preload so drivers can tune rebound and ride height to match track surfaces and driving style.

Installation notes: these units mount to standard Axial Yeti ball-end mounting points and use common hardware sizes listed by the manufacturer. When replacing existing dampers, inspect lower mounting pins and springs for wear, bleed air from the oil chambers after assembly, and test incrementally to find the preferred damper oil weight and preload setting for your setup.

These dampers are aimed at hobbyists wanting a shorter front and rear length profile for rally-style onroad setups on Axial Yeti 1/10 platforms; tune oil weight and preload to match your track conditions and driving preferences.