Axial Yeti Aluminium Steering Assembly by GPM YT048  [YT048]

Aluminium steering assembly for Yeti

This aftermarket steering assembly is a 6pcs aluminium replacement set produced by GPM for the Axial Yeti platform. It is provided as a direct-fit upgrade to the stock steering linkages and knuckles, intended for RC-scale use only.

In practical terms the set groups the primary steering linkage components used at the front of the Yeti chassis, supplied in aluminium to offer greater stiffness and abrasion resistance compared with typical plastic parts. The parts are intended to influence steering feel and long‑term wear rather than change core geometry; installers should verify fit against their existing steering hardware before final assembly.

Installation is straightforward for model builders familiar with the Yeti steering layout: remove the matching stock pieces, transfer any bearings or hardware that must be reused, and secure the aluminium components with the original fasteners. Check steering movement for binding and re-tighten fasteners after a short test run.

For hobbyists wanting a firmer, longer‑lasting steering stack on their Axial Yeti, this GPM aluminium 6pcs set provides a simple direct replacement; confirm hardware fit and torque settings during installation.