Axial Yeti Aluminum Steering Linkage by JAZRIDER YT-25005-BK  [YT-25005-BK]

Aluminum Steering Linkage for Axial Yeti

This is an RC-scale aluminum steering linkage produced for Axial Yeti chassis and supplied by JAZRIDER under model YT-25005-BK. The part replaces standard plastic linkages to offer a stiffer connection between servo output and steering knuckles, helping keep geometry consistent under load during trail and rock racing use.

Installation is straightforward for anyone familiar with Yeti steering assemblies: remove the stock tie rods, transfer or replace the rod ends as required, and secure with the original hardware. Use a small amount of threadlocker where metal-to-metal joints meet threaded posts, and verify neutral toe before final tightening. Check and re-tighten after the first run to account for any seating of components.

For setup and tuning, the aluminum linkage acts as a stable reference when adjusting toe and Ackermann. Because it reduces flex compared to plastic parts, expect changes in steering feel that may require minor servo endpoint or trim adjustments. Regular inspection of rod ends and linkage alignment is recommended to prevent uneven wear on steering components and to maintain predictable handling on technical courses.