Axial Yeti XL Aluminum Front C-Hubs Set by JAZRIDER YTL-25001  [YTL-25001]

Aluminum front C-hubs for Yeti XL

This aluminum front C-hubs set is an RC-scale replacement designed for the Axial Yeti XL chassis, intended to stiffen the front steering assembly and support setup tuning. The part is focused on mechanical reliability and tuning function rather than cosmetic change.

Compatibility is limited to Yeti XL platform variants that accept Axial-style front C-hubs. The set is intended to replace the stock front C-hubs to provide a firmer mounting point for the steering knuckles and to reduce flex under load.

Installation follows typical C-hub swap procedures: remove front wheels and knuckles, separate the stock C-hubs, transfer any bearings and hardware that remain serviceable, fit the aluminum units in place, and reassemble. Use the original fasteners where possible and check steering geometry after assembly; minor trim or shimming of steering linkages may be needed during tuning.

Tuning role: upgrading to aluminum C-hubs helps maintain caster and camber settings under aggressive driving by reducing deformation in the hub area, which can make steering response more consistent when adjusting suspension or steering geometry.