AXIAL Yeti XL Aluminum Front Knuckle Arms by JAZRIDER YTL-25000  [YTL-25000]

Front knuckle arms for Yeti XL

This JAZRIDER YTL-25000 front knuckle arms set is an RC-scale replacement part designed specifically for axial Yeti XL chassis steering assemblies. The components are machined from aluminum to provide a stiffer mounting point than stock plastic pieces, intended to reduce flex under load and keep suspension geometry consistent during trail or bashing sessions.

The parts serve as direct swap replacements where compatible, and they play a tuning role by offering a more stable pivot for the front suspension, which can affect steering response and caster consistency. They are supplied as a set to replace both left and right knuckles; verify fitment against your Yeti XL steering setup before installation.

Installation notes: these knuckle arms mount to the existing front hub carriers and use the stock fasteners and linkage locations on Yeti XL models. Basic trimming or modification of adjacent components is not expected for standard configurations, but check clearances with your wheels and C-hubs after fitting. Routine maintenance of mating pins and bearings is recommended to maintain smooth operation.

Compatible Models

• Axial Yeti XL

Use these knuckle arms to reduce front-end flex and to provide a firmer platform for steering setup changes; keep hardware torque and bearing condition within manufacturer recommendations to avoid undue wear.