Bantam CSEAC111 8-pin connection cable for E-Station 701 charger  [CSEAC111]

Bantam 8-pin cable for E-Station 701

This Bantam CSEAC111 8-pin connection cable is an RC-scale accessory designed to link an E-Station 701 charger to the device under test or to a charge adapter. It focuses on providing a direct, serviceable connection between charger and battery harness without changing charger settings or electronics.

The cable serves as a simple lead for bench charging, connector replacement, or when routing from a charger to a custom adapter harness. Installation is typically plug-and-play: align the 8-pin mating faces, ensure pins seat without force, and confirm secure retention before powering the charger. Inspect connector orientation to avoid pin misalignment during insertion.

For maintenance, keep contact faces clean and free of debris, avoid sharp bends at the connector exit, and store the cable coiled without tight kinks. When using on a workbench, position the cable to prevent accidental tugs that could stress the connector or the charger socket.

In tuning and setup workflows the cable functions as a utility part: it simplifies swapping charger locations, enables quick connection to monitor rigs or test jigs, and makes it easier to route power between charger and auxiliary devices during setup checks. It is not a diagnostic tool by itself but supports the practical tasks around charging and bench preparation.