The RX-10F 2.0 Front Wheel Drive Competition Touring Car Kit produced by Destiny in 1/10 scale Cars series FWD drivetrain assembly kit, is classified in R/C Models - On-Road - Touring Cars - Electric Powered
Destiny DES-DRX-00008 RX-10F 2.0 1/10 Scale Front Wheel Drive Competition Touring Vehicle Kit
<Destiny RX-10F 2.0 NEW Features>
New center motor platform design, engine mount and solid layshaft bulkhead.
Brand new two pieces of 40g framework balancing fat and brand new front foam bumper.
Brand new graphite front and rear framework braces.
Brand new design solitary piece 7075 aluminum drifting servo mount.
New clamp design single bell-crank steering system and install with two bits of 5x9x3mm large ball bearing for improved dependability. 4 various Ackermann angle selectable.
New 2.25mm United States Of America high grade graphite materials for narrow design main framework, 2.0mm multi-flex design upper deck and 3.0mm front and backside reduced surprise towers.
Brand new good quality hard coated short dampers with POM pistons and 20mm damper springs.
Brand new design front and rear 7075 aluminum top bulkhead and linkage mount. It makes fine adjustment on roll center.
New 7075 aluminum rear bulkheads.
Brand new 7075 aluminum battery pack brackets.
Front springtime steel double CVD included because makes smoother in part.
<Destiny RX-10F 2.0 Features>
7075 aluminum front and rear suspension mounts. Three various size of suspension system mounts to makes wider range adjustment on course width from 40.7-49.5mm.
Vinyl eccentric bushing for suspension. Fine modification on toe-in and toe-out angle in 0.3 degree per step.
New design high quality composite front side and rear lower suspension hands, steering knuckles, c-hubs and back hubs synthetic components.
7075 aluminum front lower bulkheads.
Transmission ratio 38T/20T in ratio 1.9.
2/4/6 deg caster insert is selectable to assembly to c-hub. Big open on c-hub for simple install or remove front CVD.
In-line design on steering knuckle. Re-position ball bearings and CVD joint CENTER. Maximum decrease the noise and wheel vibration. Maximum increase steering efficient and cornering rate.
7075 aluminum wheel adaptors. Lightweight and dependable on drivetrain.
Complete set low friction layer aluminum damper balls and ball studs.
Tall precision 4 gears differential with 7075 aluminum weight reduced gear drive cups.
7075 aluminum steering and upper website link turnbuckles. Ebony color anodized.
Bearing supporting front and back anti-roll club system.
64P 102T quality spur gear.
Complete set high grade ball bearings.
