XRAY T4-20 Graphite Front Shock Tower by Factory Pro O-XCP001  [FP-O-XCP001]

Front shock tower for T4-20

This is an RC-scale graphite front shock tower designed for the XRAY T4-20 chassis, supplied as a standard replacement part by Factory Pro O-XCP001. Its primary function is to locate and secure the front shock absorbers and to influence suspension geometry and shock mounting positions.

Intended use is strictly for model car suspension tuning and repair. When fitted, the tower changes shock mounting points and can affect roll center and leverage ratios, so adjustments should be validated on-track. The part is graphite, offering a balance between stiffness and weight typical for hop-ups in 1:10 touring car setups.

Installation notes: remove the original tower following your chassis service procedure, align the replacement tower to the same reference points, and reuse the factory mounting hardware where possible. Check clearance around the servo and suspension linkages after fitting, and verify shock shaft alignment before final tightening. Perform incremental setup changes and test runs to assess handling differences.