Futaba 6EXAP 6-Channel FM 35Mhz/ R136F/ 4xS3003 [6EXAP_c5]

Price:

USD$146.00

Brand:

Futaba

Model:

6EXAP_c5

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

The 6-Channel FM 35Mhz/ R136F/ 4xS3003 produced by Futaba, is classified in R/C Models - System - Transmitter - Flight Transmitters

FEATURES:

Aileron, Elevator and Rudder dual price switch - utilize this change to ��flip�� between two aileron, elevator and rudder control throw settings. The throws can be setup you prefer, but generally speaking, if the switch is ��up�� the throws are greater (��high rate��) when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential rates (if utilized).
Flap control dial/Channel 6 - This dial operates the servo linked to channel 6 in the receiver in the event your model has flaps here is the control utilized to work them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to shift the neutral or center position of each servo as labeled inside diagram.
Asking jack - Port for charging you the transmitter batteries with all the included battery charger.
On-off switch
DATA INPUT lever - regularly replace the values associated with different functions displayed on the LCD screen.
Liquid-crystal display (LCD) - shows development modes and values joined.
MODE key - accustomed scroll through and display the ten or eleven(PCM) different functions.
CHOOSE key - accustomed display the values for the current function.
Throttle-cut button - To use the throttle-cut function, reduced the throttle stick completely, then drive the throttle-cut button to fully shut the carburetor and shut for the engine.
Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) within the receiver.
Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter needs to be linked to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - change runs the servo linked to channel 5 in the receiver when your model has retractable landing gear here is the control accustomed extend and retract the gear.
Antenna - Radiates signals towards the receiver. Never ever fly a model without completely extending the antenna or you may create interference to other modelers and decrease operational signal selection of the transmitter. The antenna may be removed and changed with another just in case its unintentionally broken.

Hot Brands

Futaba 6EXAP 6-Channel FM 35Mhz/ R136F/ 4xS3003 [6EXAP_c5]