Futaba 6EXAP 6-Channel FM 40MHz/ R156F [6EXAP_c3]

Price:

USD$115.00

Brand:

Futaba

Model:

6EXAP_c3

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

The 6-Channel FM 40MHz/ R156F produced by Futaba, is classified in R/C Models - System - Transmitter - Flight Transmitters

QUALITIES:

Aileron, Elevator and Rudder dual rate switch - Use this change to flip between two aileron, elevator and rudder control throw settings. The throws could be set up nevertheless choose, but generally, as soon as the switch is up the throws are greater (high rate) and when the switch is down the throws are less (low price). This switch additionally flips between exponential prices (if utilized).
Flap control dial/Channel 6 - This dial runs the servo linked to channel 6 within the receiver when your model has flaps here is the control utilized to use them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to move the neutral or center position of each servo as labeled within the diagram.
Charging you jack - Port for recharging the transmitter batteries aided by the included battery charger.
On-off switch
INFORMATION INPUT lever - always replace the values of various functions displayed regarding the LCD screen.
Liquid-crystal screen (LCD) - shows development modes and values entered.
MODE key - accustomed scroll through and display the ten or eleven(PCM) various functions.
PICK key - accustomed show the values for the current function.
Throttle-cut button - to make use of the throttle-cut function, lower the throttle stick all the way, then drive the throttle-cut key to totally close the carburetor and shut of engine.
Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) into the receiver.
Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter must certanly be linked to another transmitter via. a trainer cord (available individually).
Retractable landing gear switch/Channel 5 - Switch operates the servo linked to channel 5 in the receiver in case your model has retractable landing gear this is actually the control regularly extend and retract the gear.
Antenna - Radiates signals towards receiver. Never travel a model without completely extending the antenna or you may create interference with other modelers and decrease operational sign selection of the transmitter. The antenna can be removed and replaced with another in case it is accidentally broken.

INCLUDES:
Futaba 6-Channel 6EXAP transmitter
Futaba R156F Receiver
Switch Harness
Handbook

SPECS:
Transmitter
T6EXAP Transmitter with programmable mixing and 6-model memory.
Transmitting on 40 / 72 MHz musical organization.
Operating-system: 2-stick, 6-channel system
Modulation: FM(PPM) and PCM
Power supply: 9.6V NT8S600B Ni-Cd battery pack or 12V alkaline battery
Current drain: 250mA

Hot Brands

Futaba 6EXAP 6-Channel FM 40MHz/ R156F [6EXAP_c3]