Futaba 6EXAP 6-Channel FM 72Mhz/ R136F/ 4xS3003 [6EXAP_c6]

Price:

USD$146.00

Brand:

Futaba

Model:

6EXAP_c6

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

The 6-Channel FM 72Mhz/ R136F/ 4xS3003 produced by Futaba, is classified in R/C Models - System - Transmitter - Flight Transmitters

QUALITIES:

Aileron, Elevator and Rudder twin price switch - Use this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are create nevertheless choose, but generally speaking, whenever switch is ��up�� the throws are greater (��high rate��) and when the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential prices (if used).
Flap control dial/Channel 6 - This dial operates the servo linked to channel 6 in the receiver in case the model has flaps this is actually the control utilized to use them.Aileron/elevator control stick -Mounting point for optional neck band.
Trim levers (all) -Used to shift the neutral or center place of every servo as labeled in diagram.
Recharging jack - Port for asking the transmitter batteries with the included battery charger.
On-off switch
INFORMATION INPUT lever - regularly change the values associated with the different functions exhibited on the LCD display.
Liquid-crystal display (LCD) - Displays programming modes and values joined.
MODE key - regularly scroll through and show the ten or eleven(PCM) different functions.
PICK key - Used to display the values for the current function.
Throttle-cut key - to utilize the throttle-cut function, reduced the throttle stick completely, then Push the throttle-cut switch to fully close the carburetor and shut associated with engine.
Throttle/rudder control stick - runs the servos attached to channel 3 (throttle) and channel 4 (rudder) inside receiver.
Trainer switch - Operates the trainer functions. To operate as a trainer switch the transmitter should be connected to another transmitter via. a trainer cable (available separately).
Retractable landing gear switch/Channel 5 - change runs the servo linked to channel 5 into the receiver in the event your model has retractable landing gear here is the control used to extend and retract the apparatus.
Antenna - Radiates signals towards receiver. Never ever fly a model without completely extending the antenna or perhaps you may create disturbance to other modelers and decrease functional signal range of the transmitter. The antenna might be eliminated and replaced with another whenever it's accidentally broken.

Hot Brands

Futaba 6EXAP 6-Channel FM 72Mhz/ R136F/ 4xS3003 [6EXAP_c6]