Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003 Flight Transmitter for Airplanes & Helicopters  [6EXAP_c7]

Futaba 6EXAP overview

The Futaba 6EXAP is a six-channel RC flight transmitter bundle presented as a ready interface for airplane and helicopter model setups. The unit exposes direct controls for primary surfaces and engine management, plus a channel dedicated to flaps and one for retractable gear, enabling straightforward installation and field tuning without custom firmware or extra tools.

The transmitter surface maps controls to receiver channels as follows: channel 1/2/4 for primary flight surfaces, channel 3 for throttle, channel 5 for retractable landing gear, and channel 6 for flap operation when a flap servo is installed. On-board toggles and dials let pilots switch between dual-rate throws, adjust exponential, and use the throttle-cut for engine shutoff during ground handling.

• Controls: Dual-rate switch for aileron, elevator and rudder, flap control dial for channel 6, trim levers for each stick axis, throttle-cut button, trainer switch and retractable gear switch for channel 5.
• Interface: LCD display with MODE and SELECT keys, DATA INPUT lever to modify displayed values, dedicated charging jack and on/off switch.
• Included electronics indicated in model name: R136HP receiver and four S3003 servos are referenced in the product designation.
• Antenna practice: Extend the antenna fully before flight to preserve signal range and reduce interference risk with other models.

For pilots fitting a basic six-channel airframe or helicopter, the 6EXAP package presents a compact transmitter layout with dedicated physical controls for dual rates, flaps and gear, simplifying installation and field trimming while keeping the radio configuration transparent.