Futaba 6EXAP 6-Channel PCM 40Mhz/ R136HP/ 4xS3003 [6EXAP_c8]

Price:

USD$189.00

Brand:

Futaba

Model:

6EXAP_c8

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

The 6-Channel PCM 40Mhz/ R136HP/ 4xS3003 produced by Futaba, is classified in R/C Models - System - Transmitter - Flight Transmitters

QUALITIES:

Aileron, Elevator and Rudder twin rate switch - utilize this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The throws is set up however you choose, but generally speaking, when the switch is ��up�� the throws are greater (��high rate��) and when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential prices (if used).
Flap control dial/Channel 6 - This dial runs the servo connected to channel 6 into the receiver in case the model has flaps here is the control utilized to work them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to move the basic or center place of every servo as labeled within the diagram.
Charging you jack - Port for charging the transmitter batteries utilizing the included battery pack charger.
On-off switch
INFORMATION INPUT lever - regularly replace the values associated with different functions shown regarding LCD screen.
Liquid-crystal display screen (LCD) - Displays programming modes and values entered.
MODE key - accustomed scroll through and display the ten or eleven(PCM) various functions.
PICK key - Used to display the values the current function.
Throttle-cut switch - to make use of the throttle-cut function, lower the throttle stick all the way, then Push the throttle-cut switch to totally shut the carburetor and shut of motor.
Throttle/rudder control stick - runs the servos attached to channel 3 (throttle) and channel 4 (rudder) inside receiver.
Trainer switch - Operates the trainer functions. To work as a trainer switch the transmitter must certanly be connected to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - Switch operates the servo attached to channel 5 inside receiver if the model has retractable landing gear this is actually the control accustomed expand and retract the apparatus.
Antenna - Radiates signals to your receiver. Never fly a model without fully expanding the antenna or perhaps you may create interference with other modelers and decrease functional sign selection of the transmitter. The antenna can be eliminated and changed with another just in case it really is unintentionally broken.

Hot Brands

Futaba 6EXAP 6-Channel PCM 40Mhz/ R136HP/ 4xS3003 [6EXAP_c8]