Futaba 6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 [6EXAP_c9]

Price:

USD$189.00

Brand:

Futaba

Model:

6EXAP_c9

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

The 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 produced by Futaba, is classified in R/C Models - System - Transmitter - Flight Transmitters

QUALITIES:

Aileron, Elevator and Rudder dual price switch - make use of this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses is setup you choose, but generally, whenever switch is ��up�� the throws are greater (��high rate��) so when the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential rates (if used).
Flap control dial/Channel 6 - This dial operates the servo attached to channel 6 inside receiver in case the model has flaps here is the control used to work them.Aileron/elevator control stick -Mounting point for optional neck band.
Trim levers (all) -Used to shift the neutral or center place of each servo as labeled into the diagram.
Charging you jack - Port for asking the transmitter batteries utilizing the included battery pack charger.
On-off switch
DATA INPUT lever - Used to change the values of various functions displayed in the LCD display.
Liquid-crystal display screen (LCD) - Displays programming modes and values joined.
MODE key - always scroll through and display the ten or eleven(PCM) various functions.
SELECT key - regularly show the values for the present function.
Throttle-cut button - to make use of the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut key to completely shut the carburetor and shut of this engine.
Throttle/rudder control stick - Operates the servos connected to channel 3 (throttle) and channel 4 (rudder) in the receiver.
Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter must certanly be attached to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - Switch runs the servo linked to channel 5 in the receiver when your model has retractable landing gear this is the control always expand and retract the gear.
Antenna - Radiates signals to the receiver. Never ever travel a model without completely extending the antenna or perhaps you may produce disturbance to many other modelers and decrease operational sign range of the transmitter. The antenna might removed and changed with another in case its accidentally broken.

Hot Brands

Futaba 6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 [6EXAP_c9]