This Futaba replacement is an RC-scale servo horn sold as 1 pcs and supplied without packing or mounting screws. It uses the TYPE-L small-circle layout named in Futaba documentation to match the mounting pattern on specified Futaba servos, keeping the installation footprint compact for tight linkages and confined servo bays.
The part is intended for direct fit to the listed servo models; confirm spline and bore compatibility on your specific servo before installation. Typical use cases include steering and throttle/brake linkages on scale electric and nitro models where small throw adjustments and predictable geometry are required.
Installation notes: remove power from the system before swapping horns, centre the servo horn with the servo at neutral, seat the horn fully onto the spline, and secure with the appropriate screw type supplied with your servo or hardware kit. After mounting, check end-to-end travel and subtrim to avoid binding. This component is a scale RC accessory and should be treated as such during setup and tuning.
Copyright © 2008-2026 rcjaz.com All rights reserved
