Futaba FU6A13905 1000mm extension cable cord for RC servo wiring  [FU6A13905]

Servo extension cable for RC

This 1000mm extension cable is an RC-scale accessory built to extend servo and receiver signal wiring where extra reach is needed. The cord uses a 50-strand heavy-duty construction to keep the lead flexible while resisting breakage from repeated bends and routing inside model airframes, cars, or boats.

When installing, keep connections secure and protected: avoid sharp bends near solder joints, use heat-shrink or insulation tape over any re-terminated joins, and route the cable away from high-heat components. Check polarity and signal continuity before final assembly and test movement of the舵機 through its full range to confirm reliable signal transfer.

For tuning and layout, use this extension to reposition receivers or舵機 for better weight distribution, clearer antenna placement, or to tidy wiring runs. The length and strand count prioritize flexibility and manageability rather than high current delivery, so use it for signal and low-current servo leads.