Futaba FU6A15501 Noise Filter Extension Cable Cord 50-Strand Heavy Duty Wire 220mm  [FU6A15501]

Noise filter extension cable for RC use

This Futaba FU6A15501 extension cord is an RC-scale accessory designed to extend the connection between an in-line noise filter and your model electronics. The cable features a 50-strand heavy-duty conductors arrangement and a 220mm overall length as stated in the product name, giving flexible routing options in tight radio-controlled model layouts.

Intended role: the cable is used to preserve signal integrity by positioning a noise filter away from crowded component bays, and to tidy wiring runs between receivers, servos, and electronic speed controllers. This helps reduce interference risk and keeps harnesses organized without implying any use beyond RC models.

Installation notes: route the cable to avoid sharp bends and high-heat sources, secure it with tape or cable ties at anchor points, and keep power and signal runs separated where possible. Confirm connector fit with your existing filter and device wiring before final installation, and inspect crimps or terminations for secure contact after any adjustments.

Tuning and troubleshooting: if you still see noise after adding the extension and filter, check ground continuity and the quality of each connection, try alternate cable routing to increase separation from high-current leads, and verify the filter placement relative to the receiver and primary noise sources.