Futaba FU6A16801 Battery Voltage Terminal Harness Cord for CDR5000 Charger  [FU6A16801]

Voltage terminal harness for CDR5000

This Futaba FU6A16801 terminal harness cord is an RC-scale accessory designed to interface battery packs with a CDR5000 charger for voltage sensing. It serves as a dedicated voltage terminal lead to route pack voltage to the charger without modifying packs or charger housings.

Compatibility is limited to the stated application, the CDR5000 charger, so confirm your charger model before fitting. The harness is intended as a plug-in lead for voltage monitoring during charging, battery checks and bench setup tasks where pack voltage readout is required.

Installation is straightforward: connect the harness to the charger terminal exposed for voltage sensing and attach the matching battery connector to the pack’s voltage tap or main terminals as designed for your pack type. Keep connections clean and secure and avoid strain on the wire and terminals during use to maintain reliable readings.

In tuning and maintenance workflows the harness is useful for routine pack voltage checks between runs, verifying cell balance reads presented by the charger, and keeping the charger’s sensing path consistent while swapping batteries on the workbench.