Futaba FUEBB0153 150mm i-Connector cord for SVi to receiver, 30-strand wire  [FUEBB0153]

i-Connector cord for SVi to receiver

This Futaba FUEBB0153 cord is an RC-scale interface cable intended to link SVi-equipped control modules to a receiver using an i-Connector style plug. The factory designation indicates a 150mm lead and a 30-strand conductor bundle, which keeps routing flexible while maintaining a compact profile inside typical model radio bays.

Use this cord when you need a direct SVi-to-receiver connection without additional adapters. The cable's multi-strand construction makes it pliable for neat installation around servos, ESCs, and receiver mounting locations, and its length suits most compact and mid-size model installations where short, tidy runs are preferred.

Installation is straightforward: connect the i-Connector end to the SVi output on compatible Futaba components or modules and plug the opposite end into the receiver channel intended for that signal. Route the cable away from high-current motor wires and secure with minimal ties to avoid restricting suspension or steering linkages. The cord serves a routing and connection role during setup and tuning, allowing you to maintain a clean wiring layout while keeping signal paths short.