Futaba FUEBB0155 i-Connector 300mm Servo-to-Receiver Cord Cable  [FUEBB0155]

300mm i-Connector Servo Cord

This Futaba FUEBB0155 300mm i-Connector cord is an RC-scale accessory designed to link SVi-compatible servo outputs to the receiver, maintaining a low-profile wiring path inside scale models. The 30-strand conductor construction prioritises flexibility for tight routing runs behind radio trays and inside compact servo bays.

Compatibility focuses on SVi signal wiring between a servo or SVi-equipped device and the receiver input; verify your receiver supports SVi wiring conventions before fitting. The cord’s length and multi-strand composition help reduce stress on connector solder joints and allow cleaner cable management without adding bulk.

Installation notes: route the cable alongside existing harnesses, avoid sharp bends at the connector ends, and secure with light adhesive tape or cable ties to prevent chafing against chassis edges. For digital servos with high-frequency update rates, ensure connectors are fully seated and inspect for any signal noise caused by loose routing or contact wear.

Tuning and setup role: this cord is intended as a wiring component rather than a performance part; correct routing and secure connections support reliable servo response and repeatable setup during radio and servo calibration procedures.