Futaba FUEBB0158 i-Connector 500mm S3173SVi to SVi servo extension cable  [FUEBB0158]

i-Connector Servo Extension 500mm

This Futaba FUEBB0158 i-Connector cable is an RC-scale accessory intended to extend or reroute servo leads while keeping connector compatibility with S3173SVi and SVi systems. The supplied 500mm length gives room to relocate receivers or servos inside a model chassis without introducing soldered joints or custom adapters.

The cable uses a 30-strand conductor bundle to balance flexibility and signal integrity for typical hobby servos. Both ends are terminated to match S3173SVi to SVi connector interfaces so installers can plug directly into compatible servos, receivers, or extension harnesses without modifying terminals.

When installing, route the cable to avoid sharp bends and pinching points in the chassis, secure with minimal tie points to prevent chafing, and keep power and signal lines separated from noisy power wiring where possible. This part is intended to support tidy wiring layouts and easier equipment reconfiguration during setup and tuning.