Futaba FUEBS3374 BLS154 Servo Gear Set AS4167 EBS3374  [FUEBS3374]

This Futaba FUEBS3374 gear set is intended as a direct replacement pack for BLS154-series servos, providing the internal gearing needed when original parts wear or strip. The item is a service part used to restore mechanical engagement and reduce slop in a scale RC steering or control setup.

Installation overview: open the servo case, note gear stack order and orientation, remove the damaged gear(s), transfer bearings or bushings if present, fit replacement gears in the original sequence, and re-check gear mesh and endplay before closing the case. Basic hand tools and a clean bench with small trays for screws are recommended.

Tuning role: replacing worn gears restores consistent feedback and centring performance from the servo, which supports precise steering input and predictable control response during setup and trimming of scale models.

Notes and handling: keep the gear train free of grease contamination that can attract debris, verify spline alignment to the output shaft, and cycle travel after reassembly to confirm smooth, noise-free operation.