Futaba FUSG130G Retract Servo Gear Set for S30G S130G  [FUSG130G]

Retract Servo Gear Replacement

This gear set is a direct-replacement accessory intended for Futaba S30G and S130G retract servos used in RC scale models. It focuses on the mechanical gear components that transfer torque inside retract-type servos, offering a like-for-like replacement path when original gears wear or show play.

Installation and fit are straightforward for technicians familiar with hobby-grade servo disassembly: remove the servo horn and case, inspect existing gear train alignment, swap the worn gear(s) with the replacement parts, and verify free rotation before reassembling. Pay attention to mesh and shaft seating to avoid binding during reinstallation.

For tuning and maintenance, clean the gear train, check bearing and shaft runout, and use light, appropriate lubricant on gear teeth only. Replacing worn gears can restore repeatable retract motion and reduce slop that affects retraction timing and landing sequence consistency.