Futaba FUSHORN-C Standard Servo Horn Type-C D6mm 4pcs (w/o screw)  [FUSHORN-C]

Futaba Type-C servo horn overview

This Futaba FUSHORN-C Type-C servo horn is an RC-scale accessory intended for standard Futaba servo outputs, supplied as a pack of 4pcs without mounting screws. The part uses a medium circular profile with a D6mm centre hole as identified in the product title, and is intended for typical servo linkages such as steering arms, throttle linkages, or other control connections on model cars, boats, and aircraft.

In practice the horn serves as the mechanical interface between the servo output shaft and your model’s linkage. Because screws are not included, plan to use appropriate-length mounting hardware that matches your servo’s output and the horn’s D6mm centre hole. The lightweight profile and standard form factor make it a straightforward replacement or spare part when tuning mechanical throw, endpoint, or throw direction via your radio and servo settings.

When fitting, confirm the horn seats flush on the servo splined shaft and that movement is free across the full travel to avoid binding. Use the servo settings in your transmitter to fine-tune neutral position and travel to achieve the desired steering or control response without imposing excessive load on the servo.