Gmade R1 Rock Buggy Aluminium Front/Rear Bumper Absorber by GPM GM330F/R  [GM330F/R]

Aluminium Front/Rear Bumper Absorber

The Gmade R1 Rock Buggy Aluminium Front/Rear Bumper Absorber by GPM GM330F/R is an RC-scale replacement part intended for the 1/10 Gmade R1 Rock Buggy platform. It provides a metal alternative to stock components where aluminium is preferred for rigidity and repeatable mounting.

Functionally this part serves as a front and rear bumper absorber, helping manage contact forces and keeping bumper mounts aligned during hard landings or low-speed impacts on off-road tracks. The design is presented as a direct-fit hop-up for Gmade R1 Rock Buggy units and is described as a single set covering both ends.

Installation is straightforward for modders familiar with 1/10 crawler maintenance: remove the stock bumper mounting hardware, fit the aluminium absorber to the original mounting points, and reuse the vehicle’s existing fasteners where they match. No special electrical adjustments are required since this is a structural accessory for the bumper assembly only.

This aluminium absorber set is aimed at modelers who want a metal bumper interface for the Gmade R1 Rock Buggy, offering a straightforward replacement that focuses on durability and fixed mounting alignment in 1/10 scale setups.