GPM GPM023X Brass Pendulum Wheel Knuckle Axle Weight with 21mm Hex Adapter, 20pcs set  [GPM023X]

Pendulum wheel axle weight for RC crawlers

This GPM GPM023X pendulum-style wheel knuckle axle weight is a purpose-built RC-scale accessory that adds mass low on each wheel to improve traction and stability when crawling at steep or uneven angles. The weight features a central bearing and a Delrin collar, with the pendulum profile tapering toward the top so the mass hangs downward and helps the tyre hold the terrain instead of slipping or digging in.

The kit is supplied with adapters, pins, shims, washers and bearings to suit multiple crawler platforms. Use this part where you want additional downward force on the wheel to keep contact on low-angle obstacles and to smooth recovery when a tyre digs into soft ground.

Included items in the kit (as supplied):

• 31mm Hex Adapter for TRX4 - 2 pcs
• 21mm Hex Adapter for other models - 2 pcs
• Stainless Steel Pin 2x10 - 2 pcs
• 5mm Spring Steel Shims - 2 pcs
• 5mm Metal Washer w.opening - 2 pcs
• 19mm Stainless Steel Hex Socket Screws - 2 pcs
• Metal Washer for GMADE models - 2 pcs
• M4x2.5x11 Pin - 2 pcs
• 12x18x4 Bearings - 2 pcs

Key technical and fit notes taken from the manufacturer:

• The single pendulum weight is specified as 128 gram, not including the bearings and collars.
• Two hex widener sizes are provided: 31mm hex wideners intended for Traxxas TRX-4, and 21mm hex wideners for Axial SCX-10 I/II, GMADE Sawback family and HPI Venture 1165642.
• Wheels must have an inner diameter of 45mm and a wheel shaft hole of 5mm to be compatible with this kit.
• Installation location is on the outer case of the front and rear knuckle arms where this aftermarket part mounts to add mass not present on the original chassis.
• For TRX-4 use, insert the white Delrin collars on the rear side of the pendulum where there is a groove and secure the hex adapter with the supplied screw pin.
• For Axial SCX-10 I/II, GMADE Sawback/Sawback 4LS/Komodo and HPI Venture 1165642, press bearings on both sides of the pendulum and install the hex adapter directly onto the supplied steel pin.

Use this brass pendulum weight where added low-mounted mass improves wheel bite and helps keep crawlers moving smoothly through deep ruts or over steep rock faces; check wheel inner diameter and shaft hole before fitting and follow platform-specific pin and collar orientation during assembly.