GPM GPM/STAND/PA RC Car/Truck Aluminum Stand Rebuild Kit Replacement Hardware and Locking Lever  [GPM/STAND/PA]

Aluminum stand rebuild kit for RC scale

This rebuild kit replaces the factory plastic components on compatible RC car and truck stands with machined aluminum parts and supplied hardware. It is intended to restore or improve the mechanical interface of a bench stand used for setup, maintenance, and track preparation. The kit contains bearings, washers, screws, a locking lever and small assembly components to substitute the original plastic pieces while keeping the stand functionally the same.

The parts are supplied as a complete hardware set ready for installation into the stand assembly. Use basic hand tools to remove the plastic pieces and transfer the new aluminum parts and fasteners, taking care to retain alignment of shafts and bearings. The aluminum components provide a more rigid mounting point which helps maintain consistent setup geometry during repeated use.

This rebuild kit is a direct aluminum replacement for original plastic stand parts and is intended for hobby bench use where increased rigidity and repeatable setup are desired.