This is a pair of rubber front/rear radial tires shaped to a 15 degree profile for Mini-Z AWD applications designed for the Ori platform. They are an RC-scale accessory intended for small on-road setups where front and rear radial geometry is used to influence turn-in and mid-corner traction.
Functionally the shape-a profile alters contact patch behavior under steering input, helping to fine-tune neutral balance and steering return without changing suspension geometry. Use these tires to adjust bite and turn-in sensitivity in practice sessions, qualifying runs, or trimmed race setups.
Installation is straightforward: push the tire onto the wheel until the bead seats evenly, check for any wobble, and perform a short run-in at low speed to let the rubber settle. Regular inspection for wear and clean mounting surfaces will keep predictable response lap to lap.
Note: This is an RC-scale spare for Mini-Z AWD Ori platforms and is not suitable for full-size vehicles.
Copyright © 2008-2026 rcjaz.com All rights reserved
