GPM SBMT283 Steel #45 Front/Rear CVD Swing Shaft for HPI Bullet 3.0 MT and ST  [SBMT283]

Steel CVD swing shaft for HPI Bullet 3.0

This GPM SBMT283 front/rear CVD swing shaft is a steel-scale replacement part designed specifically for HPI Bullet 3.0 MT and ST chassis. As an RC drivetrain component, it targets the CVD swing shaft position to provide higher material strength than common stock parts, allowing hobbyists to address wear and flex in demanding off-road conditions.

The part is intended for direct fitment into the CVD assembly locations on supported HPI Bullet 3.0 MT and ST models; installers should verify fitment and retainers before final assembly. In tuning terms, swapping to a steel #45 shaft affects drivetrain stiffness and feedback, which can influence traction and throttle response during setup adjustments.

Use this GPM SBMT283 steel swing shaft when you need a durable, direct-fit option for front and rear CVD locations on HPI Bullet 3.0 MT and ST, and account for its increased drivetrain stiffness when tuning.