Hatroi HA151 Pipe Clamps D=60mm for 35cc Muffler  [HA151]

Pipe Clamp for 35cc Mufflers

This Hatroi HA151 pipe clamp is an RC-scale accessory designed to fasten 60mm exhaust pipes to 35cc nitro mufflers. It is intended for small nitro-powered models and focuses on holding the pipe joint steady while allowing fine alignment adjustments during setup and tuning.

The clamp suits standard 35cc RC muffler brackets where a 60mm pipe diameter is required. Installation is straightforward: position the clamp over the pipe joint, align the muffler and header, then tighten progressively to avoid distorting the pipe flange. Check fit and clearance around body mounts and nearby components before final tightening.

In tuning and maintenance, a secure clamp helps preserve exhaust seal integrity and consistent back pressure, which supports repeatable engine response. Inspect the clamp periodically for deformation and ensure fasteners are torqued simply and evenly to prevent leaks or misalignment.