Hatroi HA221 Wire Holders for 4-Cycle — compact wire routing clips for RC engines  [HA221]

Wire holders for 4-cycle RC engines

Hatroi HA221 wire holders are compact routing clips made to keep ignition leads and accessory wiring tidy on 4-cycle RC engines. They provide a low-profile way to group and guide wires so they are less likely to catch on nearby components during setup and running.

The clips fit inline with typical wiring runs used on scale 4-cycle engine installations and work with single wires or small bundles. Installation is straightforward: position the holder along the cable path, press the wire into the clip, and re-check routing after a test run to ensure nothing has moved.

For tuning and track maintenance the HA221 helps maintain consistent wire placement so sensors and ignition leads remain clear of moving parts and away from areas where abrasion might occur. Use them as part of a tidy wiring layout to simplify troubleshooting and reduce the chance of intermittent faults caused by loose or chafed wiring.