Hirobo HI0304009 Lepton Lex stabilizer blade replacement for LEPTON LEX tail rotor  [HI0304009]

This Hirobo stabilizer blade is an RC-scale replacement part intended for the LEPTON LEX helicopter tail assembly. It serves as the tail rotor stabilizer element that affects yaw stability and tail response during flight. The part is presented as a serviceable replacement rather than a performance upgrade, and it should be considered as a component used in routine maintenance or repair.

Installation notes: remove the tail boom casing as required by your model, compare the new blade to the worn item for orientation and balance, then secure using the original mounting hardware. After fitting, verify alignment and static balance before a test hover; small trim adjustments to the tail rotor linkages may be needed to restore neutral yaw behavior. Use caution with over-tightening fasteners and inspect for clearance with the tail blade and tail rotor assembly.

Tuning role: the stabilizer blade contributes to tail damping and can influence low-speed tail control and stability during hover transitions. When troubleshooting tail oscillation or drift, check the blade for wear, cracks, or deformation and replace with a matching part number to maintain original handling characteristics.