This servo mount is listed under Hirobo's Lepton parts line and is intended as a direct replacement or service part for Lepton LEX assemblies. It serves as the mechanical interface that secures a servo to the airframe and maintains alignment of the linkage points used for flight control adjustments.
Installation is straightforward for experienced hobby technicians: remove the existing bracket, seat the mount so mounting holes align with the chassis and servo tabs, and fasten using the original hardware. Maintain careful alignment of the servo horn and linkage to avoid binding, and verify free movement through the control range before final flight checks.
In tuning and maintenance, this mount helps preserve consistent servo geometry. A properly seated mount reduces play at the linkage interface and supports repeatable setup when adjusting endpoints, centring, and trim during rotorcraft setup.
Use this part when replacing worn mounting points or when restoring factory alignment after a repair, and always confirm fit and clearance on your specific Lepton LEX airframe prior to flight.
Copyright © 2008-2026 rcjaz.com All rights reserved
