Hirobo HI0304046 Lepton LEX Tail Housing replacement part  [HI0304046]

Lepton LEX tail housing

This tail housing is an RC-scale replacement part identified by the Hirobo HI0304046 model number and intended for use with the Lepton LEX tail assembly as named. It is presented as a service replacement component to restore the tail case where wear or minor damage affects fitment or alignment.

Use this part when inspecting the tail assembly during routine maintenance or after signs of looseness around the tail shaft. The housing provides the mounting interface for the tail drive and bearings in the Lepton LEX tail section and supports correct alignment for tail control responsiveness.

Installation notes: remove the tail boom and tail-case fasteners to access the housing, transfer any bearings or internal components to the replacement housing as required, and reassemble while checking tail shaft runout and control linkage free-play. Final tuning should focus on tail trim and rotor balance rather than altering the housing itself.