Hirobo HI0304114 Stabilizer Control Arm Set for EMBLA SZM2 Stabilizer Control Arm  [HI0304114]

Stabilizer control arm set for Embla SZM2

This stabilizer control arm set is a direct replacement component intended for the EMBLA SZM2 family of RC helicopters. Its function is limited to the stabilizer linkages, providing the mechanical interface used when tuning tail response and neutralizing unwanted yaw or pitch oscillation.

The part is supplied as a set to replace worn or damaged control arms without modifying the main rotor or tail rotor systems. In workshop use it is treated as a service part for tail geometry adjustments and routine maintenance checks rather than a performance upgrade on its own.

When fitting, verify alignment and free movement through the stabilizer linkage, check for correct ball or clevis engagement, and confirm the flight controller or gyro endpoints are set to accommodate the replaced geometry. No special tools beyond standard RC maintenance tools are required.

Use this control arm set when restoring correct stabilizer geometry on EMBLA SZM2 helicopters, keeping the tail linkage functioning as designed and allowing fine tuning of tail stability during setup.