This HIROBO HI0404316 5MM miter gear is an RC-scale replacement part listed as a common component for Eagle, Freya, EX and SX helicopter models. It is intended as a direct service item for drivetrain sections that require a 90-degree gear interface, and it is sized around the 5mm gear dimension stated in the part name.
Installation focuses on correct alignment and mesh rather than torque values. Remove the worn gear, inspect adjacent bearings and shafts for wear, position the new miter gear to maintain straight shaft geometry, then secure the mounting fasteners. Verify free rotation by hand before powering the model, and run a low-speed functional check to confirm there is no binding or excessive backlash.
In setup and tuning, this miter gear primarily affects drivetrain smoothness and vibration transmission. Proper mesh and bearing condition reduce noise and premature wear, so include the gear in routine inspections and replace it when you detect scoring, chipped teeth, or inconsistent meshing during bench runs.
Copyright © 2008-2026 rcjaz.com All rights reserved
