This RC-scale stabilizer stopper is a replacement tail component for the SCEADU FZ-V platform, designed to limit stabilizer travel and assist in setting neutral and end positions in the tail assembly.
The part functions as a mechanical stop within the tail linkage area, providing repeatable positioning for adjustments and routine maintenance. It is intended for model-level use only and is not suitable for full-scale aircraft.
Installation is straightforward for hobbyists familiar with tail-case access: remove the tail cover, position the stopper on the stabilizer or linkage per the model's service layout, and secure using the existing mounting holes and screws. Small positional adjustments allow fine tuning of tail responsiveness and centring.
In tuning workflows this stopper is used to constrain travel during setup, to prevent over-travel on servo-driven tail mechanisms, and to provide a consistent reference when trimming or setting end points.
Copyright © 2008-2026 rcjaz.com All rights reserved
