Hirobo HI0414129 Freya Aileron Lever replacement part  [HI0414129]

Aileron lever for Freya

This is an RC-scale aileron lever listed as Hirobo HI0414129, supplied as a replacement component for Eagle Freya helicopter assemblies. The text below focuses on fit, basic installation practices, and the role the lever plays in control tuning for model helicopters.

Compatibility is limited to Eagle Freya parts group as indicated by the product category, so verify part codes against your Freya airframe before ordering. As a spare part it is intended to replace a worn or damaged lever in the control linkage chain and restore normal movement between the servo output and the control surface linkage.

Installation and setup notes:

• Check alignment: ensure the servo horn and linkage are centered before final tightening to avoid introducing preload.
• Hardware: use the original mounting screws and any recommended washers to maintain correct spacing and minimal lateral play.
• Range of motion: power the model and confirm the lever travels smoothly through the full travel without binding or interference.
• Fine tuning: small changes in linkage length or horn position can alter responsiveness; make incremental adjustments and re-test hover or low-speed control checks.