Hirobo HI0414217 Stabilizer Control Arm for SSR-VI helicopter stabilizer  [HI0414217]

HIROBO 0414-217 SSR-VI STABILZER CONTROL ARM #0414217
Price:
USD$21.00
Brand:
Hirobo
Model:
HI0414217
GTIN:
4512895129231
Condition:
Brand New
Write a review

Stabilizer control arm overview

This is a Hirobo replacement control arm intended for the SSR-VI stabilizer assembly on RC helicopters. The text focuses on the part's role in link geometry and tail stability rather than broad claims about durability or materials. The arm is presented as a direct component used when restoring correct control geometry, replacing worn linkage points, or refining stabilizer response during setup.

Specifications

  • Item: Stabilizer Control Arm
  • Material: Not specified
  • Model Number: HI0414217
  • Compatibility: SSR-VI

Use this control arm when restoring or adjusting SSR-VI stabilizer geometry, confirm fit before installation, and verify linkage angles during setup to maintain predictable tail response.

Is this part a direct replacement for SSR-VI stabilizer control arms?

The listing identifies the part for SSR-VI, confirm visually that mounting points and hole spacing match your helicopter before fitting.

What is the primary function of this control arm in tuning?

It sets linkage geometry for the stabilizer, affecting tail-centering and small corrective inputs used in fine tuning tail response.

Are any additional parts needed for installation?

Installation typically reuses existing linkage hardware, but inspect ball ends and mounting screws for wear and replace if needed.

How should I check fit after installing the arm?

With the helicopter powered down, move the servo through its range and inspect linkage for binding or excessive play, then verify stabilizer neutral position on the ground before flight.

Copyright © 2008-2026 rcjaz.com All rights reserved