HIROBO HI0414487 Turbulence D3 Tail Holder tail assembly part  [HI0414487]

Turbulence D3 tail holder details

This is an RC-scale tail holder designed for the Hirobo Turbulence D3 series, intended to secure the tail output linkage and support consistent tail shaft alignment. The part focuses on the mechanical interface between the tail gearbox output and the tail linkage, helping maintain repeatable geometry during setup and maintenance.

Installation is straightforward for builders familiar with RC helicopter tail assemblies: remove the original tail holder, position this holder to align the tail shaft and linkage, and fasten using the model's existing mounting points and fasteners. Verify alignment and free play before test flights, and retighten to the model's recommended torque settings.

In tuning and maintenance workflows the holder serves as a stable mounting point to reduce unwanted flex at the tail output, aiding in predictable tail control response and simplifying adjustments to tail pitch and tracking during setup.

Use this part when replacing or upgrading the tail mounting interface on Turbulence D3 helicopters to restore correct tail geometry and facilitate reliable tuning.