Hirobo HI2506026 Flat Washer 14 x 18.5 x 0.5T, 2 pcs, helicopter general part  [HI2506026]

Flat washer for helicopter general parts

This Hirobo flat washer HI2506026 is an RC-scale accessory intended for use in helicopter general parts where thin spacing or shim adjustments are required. Supplied as a pair, each item helps maintain consistent gaps between mating components and supports repeatable reassembly during maintenance or setup.

Key practical role: use these thin washers when you need small, uniform spacing for rotor head linkages, frame fittings, or other compact assemblies where precise clearance affects alignment and control feel. The listed dimension (14 x 18.5 x 0.5T) defines the inner/outer sizing and the thin profile used for fine adjustments rather than load-bearing support.

Installation notes: slide the washer onto the bolt or shaft until it seats against the mating surface, confirm alignment, and torque fasteners to manufacturer-recommended values for the specific component. For multi-washer stacks, verify total thickness before final assembly to avoid unwanted preload on bearings or linkages.